LinkSwitch-HP Current Limit Variation
Hi,
I'm working in a project that uses the IC LinkSwitch-HP Family and I would like to ask how can I find information about the current limit (ILIM) variation with the di/dt slope. I did not find this information in the technical datasheet, only fixed current limits for specific di/dt.
Best Regards,
回應
Hi Jedidiah,
Thank you for answering!
Yes, I understood this point. But how can I estimate this adjust in the current limit according to a specific application?
I found in TinySwitch-4 family datasheet a curve providing the current limit variation, considering normalized values (file attached). Is there anything like this for the LinkSwitch-HP family?
Best Regards
| Attachment | 大小 |
|---|---|
| tny.PNG | 70.49 KB |
Hi Daniel,
We don't have graph of normalized current limit versus normalized di/dt on linkswitch-hp.
What specific application do you need? Power supply is designed based on the maximum power requirement of customers. The maximum di/dt is used to calculate the design needed.
Regards,
Jedidiah
| Attachment | 大小 |
|---|---|
| I_limit_LinkSwitch-HP.PNG | 85.16 KB |
Hi Daniel,
Yes, the datsheet only provides fixed current limits for specific di/dt. That is the maximum current limit for the device you've choosed during full load condition. When the controller detects you're not operating in full load condition based on your design, it will automatically adjust the current limit and frequency.
Regards,
Jedidiah