Hi, Please respond, as we wish to do high volume flyback liek the attached, it is for FSGM0565 replacement...

So.......................

Please advise how to prove stability for the attached TOPswitch-HX (TOP255GN) Flyback which operates in Continuous Conduction Mode?

It is with 90VAC input and 24V, 0.8A output.

I calculated the feedback loop Bode plots using AN-57 by Power Integrations.

However, the Bode plots come out as nonsense. They give a crossover frequency of 11600Hz. This is above 10% of the switching frequency, and 33% of the RHPZ. -And yet the converter shows perfect stability, even when no_load_to_full_load transient.

I calculated the Power Stage transfer function using equations 9,10,11,12,13 and 15 from AN57.

I calculated the “Error Amplifier & Modulator” transfer function using equations 20,21,22,23 & 24 from AN57.

The Calculated Bode plots and schematic are as attached.

_ _ _ * * * _ _ _

Concerning AN57..

*..What equation would you use to calculate the Q in equation 15?

I used 1/R * SQRT(Ls/Cout)

Where Ls = secondary coil inductance

R = Secondary coil resistance + output capacitor ESR (ESR of cap at crossover frequency).

*..What value would you give for “open loop gain of TL431” (KTL431), in equation 23?......I used 562.

*..What value would you give for “KTOP” in equation 22?......i used 0.2.

*..What value would you give for “KOPTO” in equation 24?, ..given that the opto is in Darlington connection with the NPN…..i used a value of 40.