Top259en
I have one problem in my project.
My power supply when start with load the output is 25V and I remove the load and the voltage stay in 25V.
If I start the power supply with no load conected the power supply output is 38V and when I put the load stay in the 38V.
What is my problem?
The Bias Waveform amplitude is 32V?
댓글
This is a current driver
I do not understand your circuit. Could you please explain me a little bit about the way it operates. I am talking about the feedback circuit. I see three sensing resistors, R6, R9 and R11. But I do not see how are you sensing the output current.
I see the inverting input of your op-amp. It is connected to a fixed voltage of 2.5 through the voltage divided made by R1 and R12. The non-inverting input is connected to the return node.
I am very confused. Please explain me how it works
Thank you
I have problem with the AC-DC converter using TOP260YN, the source does not turn to put load is removed the load it usually triggers.
| 첨부 파일 | 파일 크기 |
|---|---|
| circuit used (425 KB) | 425 KB |
Hi,
Following the discussion that replied by Worf, are you saying there is a new issue? Would you please give a little bit more information that I can further support you?
I am sorry, I do not really understand "the source does not turn to put load is removed the load it usually triggers."
Could you please post your schematic?
Thank you