解决方案查找器

2SP0325V2A1-CM2500DY-24S

Dual-Channel SCALE-2 Plug-and-Play Driver for Mitsubishi’s New Mega Power Dual Module (New MPD)

產品規格型錄
下載 PDF 檢視 PDF
產品詳情

The 2SP0325 is designed to drive Mitsubishi’s 1200 V and 1700 V New Mega Power Dual Modules. The combination of New MPD and 2SP0325 results in a system with very high power density in the 1MW inverter class.

As a member of the SCALE-2 plug-and-play driver family, the 2SP0325 satisfies industry demands for optimized electrical performance and noise immunity. The highly integrated SCALE-2 chipset reduces component count by 80% when compared to conventional solutions, thus significantly increasing reliability and reducing costs. 

2SP0325 two-channel IGBT drivers are complete and extremely compact and come equipped with DC/DC converters, short-circuit protection, Dynamic Advanced Active Clamping (DA²C) and supply-voltage monitoring. The drivers are simple to use immediately after mounting with no further development or matching effort required. In this way, design cycles are minimized without compromising overall system efficiency.

Specifically matched drivers are available for all module types and electrical and fiber-optic interfaces are available. 

Interface Options
The 2SP0325 driver is available with one electrical and two fiber-optic interfaces:
Electrical Interface: 2SP0325T
The DIC20 electrical interface is very simple and easy to use.
The driver has the following terminals:

  • Power supply and GND terminals
  • 2 x drive signal inputs
  • 2 x status outputs (failure returns)
  • 1 x mode selection (half-bridge mode / direct mode)
  • 1 x input to set the blocking time.

All inputs are ESD-protected and all digital inputs have Schmitt-trigger characteristics. 

Fibre-optic interface: 2SP0325V
Fiber-optic links are used to electrically isolate the command and status-feedback signals. 2SP0325V IS equipped with versatile links.
For details, please check the product documentation.

產品規格
產品規格
支持的模組 CM2500DY-24S
最大開關頻率 5.00 kHz
IGBT電壓等級 1200 V
技術 SCALE-2
輸出功率/通道 - 最大 2.00 W
接口類型 Fiber Optic
IGBT製造商 Mitsubishi/Powerex
通道數 2
柵極峰值電流 (最大) +25 A
產品類別 Board
Product Sub-Type PnP Driver
支持的模組種類 IGBT
支持的拓撲
2-level Voltage Source
3-level NP-Clamped - Type 1
3-level NP-Clamped - Type 2
Multi-Level NP-Clamped
並行支持?
保護功能
Dynamic Adv Active Clamping
Over-voltage
Short Circuit
UVLO(Sec-side)
UVLO(Pri-side)
保形塗層?
驅動模式
Halfbridge
Direct-Independent
IGBT的連接類型 Direct
電源電壓 (典型) 15.00 V
柵極導通電壓 +15.00 V
柵極關斷電壓 --9.90 V
Voltage - DC Link Off state (60s) 990.00 V
時間 - 輸出上升 25.00 ns
時間 - 輸出下降 17.00 ns
隔離技術 Galvanic
隔離類型 Reinforced
Gate Boosting?
Gate Peak Current (Min) -25