Solution Finder Get Tech Support

TNY280PN - Line Sense Resistors on EN/UV Pin

Posted by: anandparalkar on

Hello Everyone,

Please see the attached file to review my design for a 5V, 2A and 12V, 0.3A dual output offline converter

based on the TNY280PN.  I am using the PIExpert software to generate the design.

 

There are two 2MegaOhm resistors from the DC bus to the EN/UV pin shown in the PIExpert design.

Keeping these resistors (as shown in the PIExpert design) causes the TNY280PN to do something

un-understandable.  There is no proper switching seen at the Drain pin.  Only some damped oscillations that

repeat with a 56KHz frequency.

On removing these resistors, the drain shows switching and the output voltage also builds-up correctly.

 

Obviously, I like the second result (the one without the resistor).  However, I am now confused if the

line sense resistors should be modified in value or should they just be disconnected (as they are now).

Also, keeping the the line resistors disconnected will mean the undervoltage lockout feature cannot

be supported.

 

Please advice.

Thanks,

Anand

Files

Attachment Size
dual-output-smps-5V-12V.pdf 2.43 MB