DER-286
Posted by: sonam
on
Sir
The question is regarding the connection between the feed back pin and Q2 in the schematic (in with capacitor design) while in Surge ckt(Without cap), there is no connection between them.
Can u please explain the cycle for the Q2,Q3 ckt with or without cap to get the idea of how it works?
Thanx & Regards
Sonam
The network formed by Q2 and Q3 are for open load function. Q2 collector is connected to FB pin of LNK419 as shown in Figure 4.This should not be different with Fig 3. Its a typo error (on Fig 3) and I'll feedback it to the engineer. Good catch.
Regards