Custom Transformer Shield

Posted by: RexJ on 02/03/2012

I have a special safety requirement for a copper foil shield that is 6 mil thick, but the PI Expert software has the thickness at 2 mil and is not editable (the user entry for this box is grayed out).

Is there a way to change this to 6 mil in PI Expert?

Can I get a rapid custom transformer with a copper shield this thick?

Thanks.

Comments

I really think so!

Hello,

I want to add shield winding to smps transformer of link switch design using PI expert tool. this should come between primary and secondary windings without distrubing any turns or pin allocation. how would i do it?

Hi Kajal Poovaiah N,

This post belongs to someone else.

Could you please post it as a seprate question so that your we could give specific answer to your question.

Regards,

PI-NANO