• Ultra-compact design for 400 VDC Automotive BEV applications
• Low component count (only 64 electrical components)¹
• Wide-range start-up and operating voltage from <200 VDC to 480 VDC²
• Wire wound transformer with basic isolation up to 480 VDC input and complies with Hi-Pot requirements (IEC-60664-1 and IEC-60664-4) 
• ≥92% full load efficiency across the input voltage range
• Accurate secondary-side regulation without optocouplers
• Comprehensive fault protection including output current limit and short-circuit
• INN3997CQ H100 with 3.45 V_OUT pin AR threshold
• Uses automotive qualified AEC-Q surface-mount (SMD) components³
• Low profile, 19 mm high
• Single-sided assembly (top side only) for cost-optimized manufacturing 
   

¹ - Power conversion stage only, excluding unpopulated components, input and output ports.
² - Derated power below 200 VDC input. See Figure 133.
³ - Excluding customized transformer.